RFID System Configuration Parameters
The following is a list of the four system configuration parameters required for
the operation of the SLPA as an RFID label printer/applicator. They are Media
Handling, RFID Reader, GPIO Port, and GPIO Table.
NOTE: You may need to set or configure other parameters for proper SLPA
Media Handling
This item selects the method of media handling.
1. Press the Menu key to take the SLPA offline and into Menu mode.
2. Press the Menu key to scroll through the Main menu until QUICK SETUP
3. Press either the ↑ or ↓ key to scroll through the QUICK SETUP submenu
4. Press the + or – key to scroll through the parameters until Tear Off
5. Press the Enter key to select Tear Off.
RFID Reader
This enables the RFID Reader.
1. Press the Menu key to take the SLPA offline and into Menu mode.
2. Press Menu key to scroll through the Main menu until RFID CONTROL
3. Press the ↑ or ↓ key to scroll through the RFID CONTROL submenu until
4. Press the + or – key to scroll through the parameters until Enable displays
5. Press the
GPIO Port Control
Sets the required GPIO Port Control for communication between the printer
and applicator.
1. Press the Menu key to take the SLPA offline and into Menu mode.
2. Press the Menu key to scroll through the Main menu until GPIO
3. Press the ↑ or ↓ key to scroll through the GPIO CONTROL submenu until
4. Press the + or – key to scroll through the parameters until Enable displays
5. Press the
operation.
displays.
until Media Handling displays in the first line of the LCD.
displays on the second line of the LCD.
displays.
RFID Reader displays in the first line of the LCD.
on the second line of the LCD.
↵
key to select Enable.
CONTROL displays.
GPIO Port displays in the first line of the LCD.
on the second line of the LCD.
↵
key to select Enable.
Positioning The Air Jets
53