Printronix SLPA7000 User Manual page 172

Chapter 5
Troubleshooting Display Messages
Message
DOWNLOADING TO
VALIDATOR
E-NET INIT
E-NET READY
E-NET RESET
EC SOFTWARE FAIL*
See Manual
ENTER to Stop
ERROR: DC PROGRAM
NOT VALID
172
Table 8. Message List
Explanation
Normal message when the
printer is downloading
emulation software with a
validator option installed.
NOTE: Many software builds
contain updates to the
validator option.
The NIC is initializing.
The NIC has finished initializing.
The NIC is being reset.
The printer cannot find the
engine controller program or the
validation checksum is corrupt.
1. A diagnostic test pattern
has been selected and is
running.
2. A diagnostic test pattern is
selected, but will not print.
Peel-Off or Tear-Off Media
Handling method is
selected.
The printer cannot find the data
controller program or the
validation checksum is
corrupted.
Solution
No action required.
NOTE: The validator software
update can be verified
in the F/W Revision
menu option of the
VALIDATOR menu.
It displays as:
Version: X305.
No action required.
No action required.
No action required.
1. Cycle power: power down
the printer, wait 15
seconds, then power the
printer on. If the message
reappears, go to the next
step.
2. Download the emulation. If
the message reappears,
replace the Flash SIMM.
3. Download the emulation. If
the message reappears,
replace the controller
PCBA. Write down the
message and return it with
the defective board.
1. This is a normal message.
↵
Press the (ENTER) key
to stop printing the test
pattern.
2. Remove the frame side
panel. Make sure the label
taken sensor cable is
connected to J18 on the
controller board.
1. Download the emulation
software again.
2. If the message reappears,
replace the Flash SIMM.