Quick Setup Menu - Printronix SLPA7000 User Manual

QUICK SETUP Menu

QUICK SETUP
Print Intensity
Print Speed
Print Mode
Media Handling
Paper Feed Shift
Label Length
Label Width
Ver Image Shift
Hor Image Shift
Orientation
Gap/Mark Sensor
Auto Calibrate
Save Config.
Power-Up Config.
(cont. on next page)
–3* –15 to 15
1
6 ips* 2 to 10 ips
Transfer* Direct
Tear-Off Strip* Tear-Off
2
0.00 inches* –0.50 to X inches
2, 4
4 or 6 inches* 00.1 to 99.0 inches
2, 4
4.1, 6.6, or 8.5 inches*
2
–1.00 to X inches
0.00 inches*
2
0.00 inches* –1.00 to 1.00 inches
Portrait* Landscape
Disable* Mark
Run Calibrate
1* 1 to 8
Factory* 1 to 8
Printing A Configuration
Peel-Off Cut
3
5
4
00.1 to 8.5 inches
3
Inv. Portrait Inv. Landscape
Gap Advanced Gap
Notes:
* = Default
1
Maximum value depends on the width of the printer
model and printhead.
2
You can change the unit value from inches to
millimeters under Units (in MEDIA CONTROL).
(Refer to the T5000e User's Manual .)
3
Based on the current value setting for Label Length,
up to a maximum of 12.80 inches.
4
Maximum value depends on the width of the printer
model.
5
Maximum value depends on model width and size of
DRAM installed.
Continuous
Advanced Notch
87