Printronix SLPA7000 User Manual page 191

Message
RBN TAKEUP FULL
Remove Used Rbn
REACTIVATING
HOST SERIAL
RECHARGE BATTERY
Remove Label
Table 8. Message List
Explanation
Normal message that displays
when you set Validator Funct. =
Disable in the VALIDATOR
menu or Battery Monitor =
Disable in the BATTERY
CONTROL menu.
This is the Time To Go Alert the
user can set (factory default =
1.0 Hour). This fault detection is
only supported when the ICP
(Intelligent Control Panel)
option is connected to the
printer serial port and Battery
Monitor = Enable in the
BATTERY CONTROL menu.
1. A label was detected at the
front of the printer by the
label taken sensor. This is
the normal reminder
message when Peel-Off or
Tear-Off Media Handling
has been selected.
2. A label was removed, but
the "Remove Label"
message remained.
3. The incorrect Media
Handling method is
selected.
List Of Messages
Solution
f. Verify that the ribbon
take-up motor is
connected to J8 on the
controller board.
g. Replace the ribbon
take-up motor.
5. If the message reappears,
replace the controller
PCBA. Write down the
message and return it with
the defective board.
No action required.
1. Plug the power cart cable
into an AC receptacle to
recharge the battery.
2. If recharging the battery
fails to clear the fault,
replace the battery or
batteries.
1. Remove the label from the
front of the printer to allow
the next label to print.
2. Verify that a front door
assembly is installed on the
printer and that it is properly
closed. Ensure that no
debris is obstructing the
door mirror or the Label
Taken Sensor. Verify that
the Label Taken Sensor is
connected to J18 on the
Controller PCBA. Replace
the Label Taken Sensor.
3. In the QUICK SETUP or
MEDIA CONTROL menu,
change Media Handling to
the correct selection.
191