Printronix SLPA7000 User Manual page 176

Chapter 5
Troubleshooting Display Messages
Message
FAN WARNING
FILE EXISTS
Enable Overwrite
FILE SYS FULL
Add Flash
FILE SYS FULL
Delete Files
FILE SYS FULL
Optimize & Reboot
176
Table 8. Message List
Explanation
The printer detected that the
power supply fan did not rotate
for at least a 45 second period
when it is was supposed to.
NOTE: This is a warning
message and will not
halt printing. When too
high of internal
temperature is
detected, the printer will
stop printing and
display PWR SUPPLY
HOT, PRINTER HOT,
or PRINT HEAD HOT,
based on the source.
The printer operator tried to
save a file using the name of an
existing stored file.
There is not enough flash
memory to store a file.
There is not enough flash
memory to store the file.
There is no flash memory left in
which to store files.
Solution
1. Verify that the fan rotates
when the printer is first
powered up and when the
printer moves media or
prints.
2. Ensure that the fan cable is
properly connected to
JP401 on the power supply
PCBA.
3. Verify that the correct
power supply is installed in
the printer.
4. Replace the power supply
fan.
5. Replace the power supply.
6. Replace the controller
PCBA.
Enter the PRINTER CONTROL
menu and enable the Overwrite
Files feature to overwrite an
existing file. (See "PRINTER
CONTROL Menu" on
page 127.)
Install a larger Flash SIMM and
download the emulation
software again.
Enter the PRINTER CONTROL
menu. Use the Delete Files
selection to delete unwanted
files. (See "PRINTER
CONTROL Menu" on
page 127.)
Enter the PRINTER CONTROL
menu and use the Optimize &
Reboot feature. (See
"PRINTER CONTROL Menu"
on page 127.)