Table of Contents
Advertisement
Platen
Peel Bar
Figure 15. Aligning Media
19. Align the inside edge of the media with the inside edge of the peel bar.
20. Thread the leader over the peel bar, then between the lower platen roller
and the air jet.
21. Follow the label guide arrows from the printhead, around the rollers to the
media rewind spool.
22. Fold the leading edge of the leader and insert it into the slit on the rewind
spool. Make sure the leader lines up closely to the SLPA panel.
23. Manually rotate the spool at least one turn counterclockwise.
NOTE: Hold the leader down while rotating the rewind spool to keep the
leader in place.
24. If the SLPA is being used in Thermal Transfer mode, it may be necessary
to load ribbon. See "Loading Ribbon" on page 49, otherwise proceed as
follows.
Threading The Label Roll
Media Edge
47
Advertisement
Table of Contents
Troubleshooting
