Chapter
6
Removal And Replacement Procedures
Support Assembly, Lower
Removal
1. Prepare the printer for maintenance (page 223).
2. Remove the platen (page 248).
3. Remove the media sensor assembly (page 237).
4. Remove two screws and the peel/tear assembly. (Figure 48, page 272,
items 5 and 6.)
5. Remove three screws (Figure 48, page 272, item 4) and the lower
support assembly (Figure 50, page 280, item 2).
Installation
1. Reverse the steps of the removal procedure.
NOTE: Before tightening the three screws, rotate and bias the lower support
2. Restore the printer to operation (page 224).
260
clockwise.