Install The Rfid Encoder Assembly - Printronix SLPA7000 User Manual

Install The RFID Encoder Assembly

Antenna
Cable
B
P1 Data Cable
Connector
Power Cable
Small Connector
RFID Encoder
Assembly
Figure 86. Connecting the Data, Power, and Antenna Cables
1. If you are replacing the RFID encoder assembly, read the IMPORTANT
notice and go to step 2; otherwise, go to step 4.
IMPORTANT
Connectors on each end of the data cable are unique. Connector P1
must connect to the interface board.
2. Plug the P1 data cable connector into its corresponding receptacle on the
interface board of the new RFID encoder assembly.
3. Plug the power cable small connector into its corresponding receptacle on
the interface board.
4. Plug the antenna cable into the RFID encoder:
a. For an Alien encoder, snap in the cable on the top of the encoder, in
b. For an AWID encoder, position the antenna cable vertical to the
A
Interface Board
the receptacle closest to you. (Figure 86, detail A.)
encoder, snap in the cable, then rotate the cable horizontally along
the side of the encoder. (Figure 86, detail B.)
Install The RFID Encoder Assembly
Alien Encoder
AWID Encoder
375