Setup
Removing Label Backing
If the media rewind spool needs to be unloaded during operation, proceed as
follows:
1. Press the Pause key to take the SLPA offline. Disable the product sensor
2. Tear the label backing near the media rewind hub, then reach around the
3. Pull the rewind spool away from the centerwall plate until the rewind
4. Feed a few blank labels by inserting the new edge of the label backing
5. Press the Pause key to place the SLPA online then enable the product
Threading The Label Roll
if necessary.
rewound backing, placing your fingers behind the hub of the media rewind
spool.
release bars collapse toward the center of the hub, then pull off the used
label backing. The rewind hub will snap back into position near the
centerwall once the used label backing is removed.
into the slit on the rewind spool and manually rotate the spool at least one
turn counterclockwise.
sensor to continue operation.
Figure 9. The Printhead Assembly
Removing Label Backing
Pivoting Deck
Deck Lock Lever
41