Table of Contents
Advertisement
8. Insert the BNC connector into the BNC connector hole in the wireless
interface.
9. Slide the BNC connector washer and nut onto the RF cable and install
them onto the BNC connector.
10. Route the radio card connector end of the RF cable through the radio
card connector hole in the wireless interface.
BNC Connector
Hole
BNC Connector
Figure 77. Installing the RF Cable onto the Wireless Interface
Radio Card
Connector Hole
Install The Dual NIC Wireless Interface
Wireless
Interface
RF Cable
Radio Card
Connector
BNC Connector
Washer
BNC Connector Nut
363
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the SLPA7000 and is the answer not in the manual?
Questions and answers