Quick Setup Submenus - Printronix SLPA8000 User Manual

Chapter 3
QUICK SETUP Menu
QUICK SETUP
(cont. from previous page)
7
SMT: Status
Disable*
8
PAA: Status
Disable*
NOTE: Many QUICK SETUP submenus are available in other main menus.

QUICK SETUP Submenus

Print Intensity
This menu item specifies the level of thermal energy from the printhead to be
used for the type of media and ribbon installed.
Large numbers imply more heat (thermal energy) to be applied for each dot.
This has a significant effect on print quality. The print intensity and speed
must match the media and ribbon type to obtain the best possible print quality
and barcode grades.
The range is –15 through +15. The default is –3.
Print Speed
This menu item specifies the speed in inches per second (ips) at which the
media passes through the SLPA while printing.
The range is 1 through 10 ips (in increments of 1 ips).
The default is 6 ips.
NOTE: The maximum print speed varies based on maximum printer width
86
Enable
Enable
Changes made in the QUICK SETUP menu are updated in the other
main menus, and vice versa.
and dot per inch (dpi) resolution of the printhead installed (203 or 300
dpi).
Notes:
* = Default.
7
Appears only if RFID is installed
8
Appears only if RFID is not installed.