Save Config - Printronix SLPA7000 User Manual

Chapter 3
QUICK SETUP Menu
select Mark, the Sensed Distance should match the length from the leading
edge of one black mark to the leading edge of the next black mark.
Auto Calibrate supports label lengths up to 24 inches.

Save Config.

Allows you to save up to eight unique configurations to meet different print job
requirements. This eliminates the need to change the parameter settings for
each new job. The configurations are stored in memory and will not be lost if
you turn off the printer.
The default is 1.
Power-Up Config.
You can specify the Factory configuration or any one of the eight possible
saved configurations as the power-up configuration.
The default is Factory.
SMT: Status
See "Software Migration Tools (SMT)" in the RFID Labeling Reference
Manual .
•
Disabled.The printer disables the use of the Software Migration Tools.
•
Enabled. The printer enables the use of the Software Migration Tools.
SMT: Sel Toolset
See "Software Migration Tools (SMT)" in the RFID Labeling Reference
Manual .
•
Toolset [1]. SMTs for PGL emulation.
•
Toolset [2]. SMTs for PPI1 emulation.
•
Toolset [3] and Toolset [4]. Reserved for internal use and future design.
SMT: Select Tool
See "Software Migration Tools (SMT)" in the RFID Labeling Reference
Manual .
•
EPC, GTIN, UPCA, EAN8, EAN13, and UCC128. SMTs displayed if
Toolset [1] is selected under SMT: Sel Toolset.
•
zEPC, zGTIN, zUPCA, zEAN8, zEAN13, and zUCC128. SMTs displayed
if Toolset [2] is selected under SMT: Sel Toolset.
NOTE: Undocumented options are reserved for internal use and future
94
design.