Auto Retry - Printronix SLPA7000 User Manual

Chapter 3
RFID CONTROL Menu
PreErase Class 0+
IMPORTANT
If you set PreErase Class 0+ to Disable, no erase cycle will occur and
pre-programmed tags are not guaranteed to program correctly.
This menu item enables or disables an automatic erase cycle forced on a
Class 0+ tag before the tag is programmed. If an error occurs during the initial
encoding, the ensuing retries will also include an automatic erase cycle.
If the tags are used and are known to have been previously written to, an
erase cycle will be necessary. Many virgin Class 0+ tags are delivered pre-
programmed, also requiring an erase cycle.
The default is Enable.

Auto Retry

This menu item selects the number of automatic (internal) retries that the
printer will attempt on the same tag before declaring a tag error and
performing the Error Handling mode selected (Overstrike, Stop, or None). The
default is 2.
Custom Tag
This menu item enables or disables the Custom Pwr Set, Custom Tag Len,
and Custom Tag Class submenus (custom tag menus). The default is
Disable.
The custom tag menus allow the RFID encoder to work with tag types that are
not listed in the Tag Type menu item.
NOTE: Printronix cannot guarantee the performance of tag types not certified
When Custom Tag is set to Disable, the settings in the custom tag menus are
ignored by the RFID encoder.
When it is set to Enable, the RFID encoder uses the settings in the custom tag
menus, which must be set to match the characteristics of the custom tag.
When it is set to Duplicate, the settings of the selected Tag Type menu item
are copied into the custom tag menus.
Custom Write Pwr
NOTE: To enable this menu item, set Custom Tag to Enable.
This menu item selects the write power level to be used in the RFID encoder.
1 is the lowest power level setting, and 20 is the highest. The default is 5.
Custom Read Pwr
NOTE: To enable this menu item, set Custom Tag to Enable.
This menu item selects the read power level to be used in the RFID encoder.
1 is the lowest power level setting, and 20 is the highest. The default is 5.
100
by Printronix.