Table of Contents
Advertisement
Optional Mounting Accessories
Figure 3. Mounting Hole Configuration
CAUTION
The mounting plates of the SLPA are 0.375 inches (9.25 mm) thick.
When mounting the SLPA, use screws that will secure the assembly into
place but will not penetrate deeper than 1/2 inch (12.7 mm) in the SLPA.
IMPORTANT
Retain cap screws in mounting holes that are not to be utilized.
Optional Mounting Accessories
See "Mounting Accessories" on page 328.
Mounting The Beacon
See "Mounting The Beacon" on page 327.
29
Advertisement
Table of Contents
Troubleshooting
