Mounting Accessories; U-Arm And Accessories - Printronix SLPA7000 User Manual

Appendix

Mounting Accessories

Mounting Accessories

U-Arm And Accessories

3/8-16 Socket Head
Cap Screw (4)
3/8 in. Washer
Mounting Clamp (2)
Support Rod (2)
The SLPA is designed so that it can be mounted to a stand, or other fixturing
device, using button head socket screws and U-arm. The offset arms are
provided to adapt the SLPA for mounting to the U-arm.
NOTE: The optional mounting stand that can be purchased with the SLPA
1. Secure the support rod to the side plates of the SLPA using the two
washers and four socket screws provided. (If the U-arm was purchased
with your SLPA, this may already be done.)
2. Secure the U-arm to the stand, or other mounting device using the two
mounting clamps, two 3/8 inch washers, and four 3/8-16 soc
screws
3. Insert the support rods of the offset arms into the recessed section of the
U-arm and hold into place.
328
Socket Screw (4)
3/8 in. Washer
Figure 69. U-Arm and Offset Arms
utilizes the U-arm configuration.
provided.
U-Arm
ket head cap