F
Installation And Removal
This document also describes how to replace an RFID antenna or encoder
assembly, or both, in a SLPA.
Prepare The Printer
1. Since you may be reloading the flash memory, make a configuration
printout of all saved configurations. (Refer to the SL5000e/T5000e User's
Manual .)
2. Set the printer power switch to O (Off).
WARNING
Always unplug the printer power cord from the printer or power outlet
before doing any replacement procedure. Failure to remove power could
result in injury to you and damage the equipment. You will be instructed
when to apply power.
3. Unplug the printer power cord from the printer or the AC power source.
RFID Encoder and
Antenna Assemblies
369