Chapter
6
Removal And Replacement Procedures
Motor, DC Ribbon Drive
Removal
1. Prepare the printer for maintenance (page 223).
2. Remove the access panels (page 226).
3. Disconnect the appropriate DC ribbon drive motor cable assembly from
the controller board:
a. Disconnect the upper (ribbon take-up) DC ribbon drive motor cable
b. Disconnect the lower (ribbon supply) DC ribbon drive motor cable
4. Remove the DC motor cable assembly from tie wraps and wire saddles
and note the cable routing.
5. Remove the two screws securing the DC ribbon drive motor assembly to
the frame.
Installation
1. Reverse the steps of the removal procedure.
2. Restore the printer to operation (page 224).
242
from connector J8 on the lower right edge of the controller board.
(Figure 40, page 241.)
from connector J16 on the upper right edge of the controller board.
(Figure 40.)