Admin User Submenus
To see these submenus, set Admin User to Enable in the PRINTER
CONTROL menu. (See "Admin User" on page 135.)
IMPORTANT
Admin User submenus should only be used by authorized personnel.
Tag Type
This menu item selects the tag type in use. The following is a list of tag types
available. Other types may be added in the future.
•
Alien Squig 64 (default)
Class 1, read/write, 64 bit, general purpose 4 inches wide
•
Alien Squig 96
Class 1, read/write, 96 bit, general purpose 4 inches wide
•
Alien M-TAG 64
Class 1, read/write, 64 bit, general purpose 4 inches wide
•
Alien M-TAG 96
Class 1, read/write, 96 bit, general purpose 4 inches wide
•
RAF Omni 313 64
Class 1, read/write, 64 bit, general purpose 3 inches wide
•
RAF Omni 432 96
Class 1, read/write, 96 bit, general purpose 3 inches wide
•
Matrics1020 64/96
Class 0, read only, 64/96 bits, preprogrammed by manufacturer, 4 inches
wide
•
Matrics2020 64/96
Class 0+, read/write, 64/96 bits, general purpose, 4 inches wide
•
RAFUCode 450 96
Class 1.19, read/write, 96 bits, general purpose, 3 inches wide
•
RAFUCode 477 96
Class 1.19, read/write, 96 bits, general purpose
•
Impinj Zuma 64/96
Class Impinj Zuma, read/write, 64/96 bits, general purpose
RFID Test (This Test Reads A Tag)
IMPORTANT
This menu item does not position the RFID tag over the antenna. Make
sure to position the tag over the antenna to receive an accurate reading.
This menu item reads the tag in range of the internal RFID antenna and
reports the tag data to the debug port and momentarily displays it on the
control panel's LCD. It is primarily intended for development verification by
checking that the system is working.
Admin User Submenus
99