Chapter
6
Removal And Replacement Procedures
Installation
1. Reverse the steps of the remove procedure.
2. Restore the printer to operation (page 224).
NOTE: Later version controller PCBAs do not have an actuator on J15; the
When inserting the media sensor cable into the J15 connector, follow these
steps:
1. Make sure the actuator is in the unlocked (pulled out) position.
2. Insert the ribbon cable with its contact pins facing toward the front of the
printer.
3. Push in the black actuator to lock the cable in place.
238
Figure 37. Unlocking the J15 Connector
sensor cable just pushes in.
Figure 38. Locking the J15 Connector
Actuator
4 Pin Media
Sensor Cable