Install The Radio Card, Protective Cover, And Antenna - Printronix SLPA7000 User Manual

Install The Radio Card, Protective Cover, And Antenna

NOTE: If the card you have appears different than shown in Figure 79,
1. Insert the radio card into the wireless interface as shown in Figure 79.
2. Install the RF cable into the top receptacle in the radio card.
3. Install the protective cover over the radio card using two M3x8mm
screws.
4. Plug the antenna onto the BNC connector.
Antenna
Radio Card
Top Receptacle
Protective
Cover
M3x8mm
Screw (2)
Figure 79. Installing the Radio Card, Protective Cover, and Antenna
Install The Radio Card, Protective Cover, And Antenna
installation is the same.
If your card has a protective cap covering the RF cable receptacle,
use a very small slot screwdriver to remove it.
BNC
Connector
RF Cable
365