Table of Contents
Advertisement
Chapter
3
RFID CONTROL Menu
RFID CONTROL
(cont. from previous page)
Custom Tag
Custom Write Pwr
Custom Read Pwr
Custom Tag Len
Custom Tag Class
EPC Mgr Report
Non-RFID Warning
RFID CONTROL Submenus
RFID Reader
This menu item enables or disables the RFID encoder. The default is Enable.
Error Handling
This menu item selects the error handling mode for RFID failures. The default
is Overstrike.
In Overstrike mode, each failed label prints with the Overstrike pattern and the
form retries on a new label until the Label Retry count is exhausted. Whether
or not an error message will display or the failed label will reprint depends
upon the Max Retry Error setting.
In None mode, no specific action is taken when a tag fails to be programmed.
In Stop mode, when a tag fails to be programmed, the printer will halt and
display the error message "RFID Error: Check Media." The label is discarded
and reprinting of the label (if desired) must be initiated from the host. When
the error is cleared, the label with the failed tag moves forward until the next
label is in position to be printed.
96
Disable *
Enable
Duplicate
5 *
1 to 20
5 *
1 to 20
8 *
8 to 32
Class 1 *
Class 0
Class 0+
Disable *
Enable
Disable *
Enable
Notes:
* = Default.
Italicized items appear only when Admin User is set
to Enable (in the PRINTER CONTROL menu).
Class 1.19
Class Zuma
Advertisement
Table of Contents
Troubleshooting
