Rfid Stgl Commands; Rfid Write; Rfid Write (Ip0), Rfid Read (Ip1) - Printronix SL4M Reference Manual
Rfid labeling
Hide thumbs
Also See for SL4M:
- User manual (308 pages) ,
- Reference manual (78 pages) ,
- Quick setup manual (68 pages)
Table of Contents
Advertisement
Chapter 2
RFID STGL Commands
RFID STGL Commands
RFID Write
Purpose
Format
Example
RFID Write (IP0), RFID Read (IP1)
Refer to your SATO programmer's reference manual for a
description of the RFID command syntax for IP0 and IP1.
82
This command specifies data to be written into RFID
tags.
<ESC>RK 1,a,b,D16,c..c
a
RFID tag Error Ignore. 0 = Disable (default
when value is omitted), 1 = Enabled, 2 to 9
= Auto retry on tag error.
This command is ignored for STGL. The
error handling for all RFID commands on
all supported emulations is set according
to the RFID menu on the front panel. Using
the RFID menu, the user can set the error
handling, number of retries, and tag type.
b
Write Protector Designation. Valid range is
0 to 1. 0 = Fixed (default).
D
Writes data size in number of characters.
Valid data size is 16 characters.
16 or 24
Specification of Writing Data Size. Valid
data size is 16 or 24 characters.
c..c
EPC data (fixed at 16 characters). Valid
range is 0 to 9 or A to F only.
<ESC>RK1,0,0,D16,ABCDEF1234567543
Advertisement
Table of Contents
