Removing Label Backing; Slpa System Configuration Parameters - Printronix SLPA8000 User Manual

Removing Label Backing

If the media rewind spool needs to be unloaded during operation, proceed as
follows:
1. Press the Pause key to take the SLPA offline.
2. Tear the label backing near the media rewind hub, then reach around the
3. Pull the rewind spool away from the centerwall plate until the rewind
4. Feed a few blank labels by inserting the new edge of the label backing
5. Press the Pause key to place the SLPA online.

SLPA System Configuration Parameters

The following is a list of the system configuration parameters required for the
operation of the SLPA as an RFID label printer/applicator.
NOTE: You may need to set or configure other parameters for proper SLPA
Media Handling
This item selects the method of media handling.
1. Press the Menu key to take the SLPA offline and into Menu mode.
2. Press ↓ and
3. Press the Menu key until QUICK SETUP displays.
4. Press ↑ or ↓ until Media Handling displays.
5. Press + or – until Tear Off displays.
6. Press
rewound backing, placing your fingers behind the hub of the media rewind
spool.
release bars collapse toward the center of the hub, then pull off the used
label backing. The rewind hub will snap back into position near the
centerwall once the used label backing is removed.
into the slit on the rewind spool and manually rotate the spool at least one
turn counterclockwise.
operation.
↵
at the same time until ENTER SWITCH UNLOCKED
displays.
↵
to select Tear Off.
Removing Label Backing
51