Saving The Configuration
After customizing your settings, save them as a configuration:
1. Press the
2. Press ↑ or ↓ until Save Config. / 1* displays.
3. If necessary, press + or – until the desired configuration displays.
4. Press
NOTE: You can specify a 15-character name for your configuration. See
5. If necessary, set your newly saved configuration as the Power-Up
Selecting The Power-Up Configuration
To have a saved configuration automatically loaded when you power up the
printer, set the saved configuration as the Power-Up configuration:
1. Press the
2. Press ↑ or ↓ until Power-Up Config. / Factory* displays.
3. Press + or – until the desired configuration displays.
4. Press
Loading A Saved Configuration
To use a different configuration, load a saved configuration:
1. Press the PAUSE key until OFFLINE displays.
2. Press the JOB SELECT key until the desired configuration displays.
3. Press
WARNING
Prior to any maintenance procedures, be sure to power off the SLPA
and disconnect the power cord and air supply hoses unless otherwise
indicated.
WARNING
Maintenance operation should only be performed by a trained and
qualified technician.
. .
key to enter the QUICK SETUP menu.
.
↵
. Saving Configuration displays briefly.
"Name Config (1-8)" in the User's Manual .
configuration. See "Selecting The Power-Up Configuration" below.
. .
key to enter the QUICK SETUP menu.
.
↵
. An asterisk (*) displays next to the selected configuration.
↵
. Loading Saved / Configuration displays.
QUICK SETUP Menu Items
37