Ipv6-Based Vrrp Configuration Examples - 3Com S7906E Configuration Manual

# If Switch A fails, use the display vrrp verbose command to display the detailed information of VRRP
group 1 on Switch C.
[SwitchC-Vlan-interface2] display vrrp verbose
IPv4 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface Vlan-interface2
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Master IP
Forwarder Information: 3 Forwarders 2 Active
Config Weight
Running Weight : 255
Forwarder 01
State
Virtual MAC
Owner ID
Priority
Active
Redirect Time
Time-out Time
Forwarder 02
State
Virtual MAC
Owner ID
Priority
Active
Forwarder 03
State
Virtual MAC
Owner ID
Priority
Active
The above information indicates that if Switch A fails, Switch B becomes the master, Switch C becomes
the AVF among the VFs corresponding to the virtual MAC address 000f-e2ff-0011, and packets sent
from Host A to the external network are forwarded by Switch C.

IPv6-Based VRRP Configuration Examples

This section provides these configuration examples:
Single VRRP Group Configuration Example
VRRP Interface Tracking Configuration Example
: Load Balance
: Virtual MAC
: 1
: Up
: 100
: Yes
: None
: 10.1.1.1
: 10.1.1.3
: 255
: Active
: 000f-e2ff-0011 (Take Over)
: 0000-5e01-1101
: 85
: local
: 577 secs
: 1777 secs
: Listening
: 000f-e2ff-0012 (Learnt)
: 0000-5e01-1103
: 85
: 10.1.1.3
: Active
: 000f-e2ff-0013 (Owner)
: 0000-5e01-1105
: 255
: local
1-37
Adver Timer : 1
State : Backup
Running Pri : 100
Delay Time : 5