Snmp Logging Configuration Example - 3Com S7906E Configuration Manual

Execute the shutdown or undo shutdown command to an idle interface on the agent, and the
NMS receives the corresponding trap.

SNMP Logging Configuration Example

Network requirements
As shown in
The IP address of the NMS is 1.1.1.2/24
The IP address of the agent is 1.1.1.1/24
Configure SNMP logging on the agent to record the operations performed by the NMS to the agent
Figure 1-5 Network diagram for SNMP logging
Configuration procedure
For the configurations for the NMS and agent, refer to
SNMPv3 Configuration
# Enable logging display on the terminal. (This function is enabled by default, so that you can omit this
configuration).
<Sysname> terminal monitor
<Sysname> terminal logging
# Enable the information center to output the system information with the severity level equal to or
higher than informational to the console port.
<Sysname> system-view
[Sysname] info-center source snmp channel console log level informational
# Enable SNMP logging on the agent to log the GET and SET operations of the NMS.
[Sysname] snmp-agent log get-operation
[Sysname] snmp-agent log set-operation
The following log information is displayed on the terminal when the NMS performs the Get
operation to the agent.
%Jan 1 02:49:40:566 2006 Sysname SNMP/6/GET:
Figure 1-5, the NMS and the agent are connected through an Ethernet.
Example.
SNMPv1/SNMPv2c Configuration Example
1-12
and