Displaying And Maintaining Hotfix; Hotfix Configuration Examples - 3Com S7906E Configuration Manual

To do...
Enter system view
Delete the specified patches
from the memory patch area
Follow the steps below to delete patches: (distributed IRF device)
To do...
Enter system view
Delete the specified patches
from the memory patch area

Displaying and Maintaining Hotfix

To do...
Display the patch information

Hotfix Configuration Examples

Hotfix Configuration Example
Network requirements
The software running on Device is of some problem and thus hotfixing is needed.
The patch files patch_mpu.bin (for the AMB) 、patch_lpr.bin and patch_lpb.bin are saved on the
TFTP server.
The IP address of Device is 1.1.1.1/24, and IP address of TFTP Server is 2.2.2.2/24. An available
route exists between Device and TFTP Server.
Figure 1-6 Network diagram of hotfix configuration
Configuration procedure
1) Configure FTP Server. Note that the configuration varies depending on server type and the
configuration procedure is omitted.
Enable the TFTP server function.
Save the patch files patch_mpu.bin 、patch_lpr.bin and patch_lpb.bin to the directory of the
TFTP server.
Use the command...
system-view
patch delete patch-number
slot slot-number
Use the command...
system-view
patch delete patch-number
chassis chassis-number slot
slot-number
Use the command...
display patch information
1-10
Remarks
—
Required
Remarks
—
Required
Remarks
Available in any view