Tuning Mpls Te Tunnel Setup - 3Com S7906E Configuration Manual

Follow these steps to configure the administrative group and affinity attribute:
To do...
Enter system view
Enter interface view of MPLS
TE link
Assign the link to a link
administrative group
Exit to system view
Enter MPLS TE tunnel interface
view
Configure the affinity attribute
of the MPLS TE tunnel
Submit current tunnel
configuration
Configuring CR-LSP reoptimization
Dynamic CR-LSP optimization involves periodic calculation of paths that traffic trunks should traverse. If
a better route is found for an existing CR-LSP, a new CR-LSP will be established to replace the old one,
and services will be switched to the new CR-LSP.
Follow these steps to configure CR-LSP reoptimization:
To do...
Enter system view
Enter MPLS TE tunnel interface
view
Enable reoptimization for the
MPLS TE tunnel
Submit current tunnel
configuration
Exit to user view
Perform reoptimization on all
MPLS TE tunnels with
reoptimization enabled

Tuning MPLS TE Tunnel Setup

This section only covers the configuration tasks for tuning MPLS TE tunnel setup.
Use the command...
system-view
interface interface-type
interface-number
mpls te link administrative
group value
quit
interface tunnel
tunnel-number
mpls te affinity property
properties [ mask mask-value ]
mpls te commit
Use the command...
system-view
interface tunnel
tunnel-number
mpls te reoptimization
[ frequency seconds ]
mpls te commit
return
mpls te reoptimization
1-27
Remarks
––
––
Optional
The default is 0x00000000.
––
––
Optional
The default affinity attribute is
0x00000000, and the default
mask is 0x00000000.
Required
Remarks
––
––
Required
Disabled by default
Required
––
Optional