Poe Configuration Example - 3Com S7906E Configuration Manual

Display the state information of the
PoE power supply
Display the state information of the
PoE power supply (distributed IRF
device)
Display the information of the
monitoring module of the PoE power
supply
Display the information of the
monitoring module of the PoE power
supply (distributed IRF device)
Display the switch information of the
PoE power supply
Display the switch information of the
PoE power supply (distributed IRF
device)
Display all information of the
configurations and applications of the
PoE profile
Display all information of the
configurations and applications of the
PoE profile applied to the specified
PoE interface

PoE Configuration Example

Network requirements
As shown in Figure
The device is equipped with two PoE-supporting cards, which are inserted in Slot 3 and Slot 5
respectively. The PSE IDs are 4 and 6.
Allocate 400 watts to PSE 4, provided the default maximum power to PSE in PSE 6 can meet the
requirements.
GigabitEthernet 3/0/1 and GigabitEthernet 3/0/2 are connected to IP telephones.
GigabitEthernet 5/0/1 and GigabitEthernet 5/0/2 are connected to AP devices.
The power supply priority of GigabitEthernet 3/0/2 is critical. When a new PD results in PSE power
overload, the PSE does not supply power to the new PD according to the default PoE interface
power management priority policy.
The power of the AP device connected to GigabitEthernet 5/0/2 does not exceed 9000 milliwatts.
To do...
1-2,
Use the command...
display poe-power status
display poe-power status
[ chassis chassis-number ]
display poe-power
supervision-module
display poe-power
supervision-module [ chassis
chassis-number ]
display poe-power switch state
display poe-power switch state
[ chassis chassis-number ]
display poe-profile [ index
index | name profile-name ]
display poe-profile interface
interface-type interface-number
1-15
Remarks