3Com S7906E Configuration Manual page 1722

Fec
Nexthop
In-Label
Out-Label
In-Interface
Out-Interface
LspIndex
Tunnel ID
LsrType
Bypass In Use
BypassTunnel
Mpls-Mtu
------------------------------------------------------------------
LSP Information: BGP
------------------------------------------------------------------
No
VrfIndex
Fec
Nexthop
In-Label
Out-Label
In-Interface
Out-Interface
LspIndex
Tunnel ID
LsrType
Outgoing Tunnel ID
Label Operation
Perform the display interface tunnel command on PE 1. You can see that traffic is being forwarded
along the CR-LSP of the TE tunnel.
[PE1] display interface tunnel 1
Tunnel1 current state: UP
Line protocol current state: UP
Description: Tunnel1 Interface
The Maximum Transmit Unit is 1500
Internet Address is 12.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group not set
Tunnel source unknown, destination 3.3.3.3
Tunnel protocol/transport CR_LSP
Last 300 seconds input:
Last 300 seconds output:
34 packets input,
0 input error
34 packets output,
0 output error
: 2.2.2.2/32
: 10.0.0.1
: 3
: NULL
: Vlan-interface2
: ----------
: 2051
: 0x430000e
: Exgress
: Not Exists
: Tunnel Index[---]
: 1500
LSP
: 3
: vpn1
: 192.168.1.0/24
: 192.168.1.1
: 1024
: NULL
: ----------
: ----------
: 8193
: 0x0
: Egress
: 0x0
: POP
5 bytes/sec, 0 packets/sec
5 bytes/sec, 0 packets/sec
2856 bytes
2856 bytes
1-73