If you find that an ACTIVE patch is of some problem, you can reboot the device to deactivate the patch,
so as to avoid a series of running faults resulting from patch error.
Follow the steps below to activate patches: (distributed device)
To do...
Enter system view
Activate the specified patches
Follow the steps below to activate patches: (distributed IRF device)
To do...
Enter system view
Activate the specified patches
Confirming Running Patches
After you confirm the running of a patch, the patch state becomes RUNNING, and the patch is in the
normal running stage. After the device is reset or rebooted, the patch is still valid.
Follow the steps below to confirm the running of patches: (distributed device)
To do...
Enter system view
Confirm the running of the
specified patches
Follow the steps below to confirm the running of patches: (distributed IRF device)
To do...
Enter system view
Confirm the running of the
specified patches
This operation is applicable to patches in the ACTIVE state only.
Use the command...
system-view
patch active patch-number
slot slot-number
Use the command...
system-view
patch active patch-number
chassis chassis-number slot
slot-number
Use the command...
system-view
patch run patch-number [ slot
slot-number ]
Use the command...
system-view
patch run patch-number [ chassis
chassis-number slot slot-number ]
1-8
Remarks
—
Required
Remarks
—
Required
Remarks
—
Required
Remarks
—
Required