Configuring Mpls Te Basic Capabilities - 3Com S7906E Configuration Manual

Configuring MPLS TE Basic Capabilities

Configuring
an MPLS TE
tunnel
Configuring RSVP-TE Advanced Features
Tuning CR-LSP Setup
Tuning MPLS TE Tunnel Setup
Configuring Traffic Forwarding
Configuring Traffic Forwarding Tuning Parameters
Configuring CR-LSP Backup
Configuring FRR
Configuring MPLS TE Basic Capabilities
MPLS TE basic capabilities are essential to MPLS TE feature configurations. After configuring the basic
capabilities, you need to make other configurations in order to use MPLS TE depending on the actual
requirements.
Configuration Prerequisites
Before the configuration, do the following:
Configure static routing or IGPs to make sure all LSRs are reachable.
Configure MPLS basic capabilities.
For configuration information about MPLS basic capability, refer to MPLS Basics Configuration in the
MPLS Volume.
Configuration procedure
Follow these steps to configure MPLS TE basic capabilities:
To do...
Enter system view
Enter MPLS view
Task
Creating MPLS TE Tunnel over Static CR-LSP
Configuring MPLS TE Tunnel with Dynamic Signaling Protocol
Use the command...
system-view
mpls
Forwarding traffic along MPLS TE
tunnels using static routes
Forwarding traffic along MPLS TE
tunnels through automatic route
advertisement
1-14
Remarks
Required
Required
Use either
approach
Optional
Optional
Optional
Required
Use any approach
Optional
Optional
Optional
Remarks
––
––