3Com S7906E Configuration Manual page 1706

Vlan-int3
Configuration procedure
1) Assign IP addresses and masks to interfaces (see
Omitted
2) Configure the IGP protocol
# Enable IS-IS to advertise host routes with LSR IDs as destinations on each node. (Omitted)
Perform the display ip routing-table command on each switch. You should see that all nodes learnt
the host routes of other nodes with LSR IDs as destinations. Take Switch A for example:
<SwitchA> display ip routing-table
Routing Tables: Public
Destinations : 13
Destination/Mask Proto
1.1.1.1/32 Direct 0
2.1.1.0/24 Direct 0
2.1.1.1/32 Direct 0
2.2.2.2/32 ISIS
3.1.1.0/24 ISIS
3.2.1.0/24 ISIS
3.3.1.0/24 ISIS
3.3.3.3/32 ISIS
4.1.1.0/24 ISIS
4.4.4.4/32 ISIS
5.5.5.5/32 ISIS
127.0.0.0/8 Direct 0
127.0.0.1/32 Direct 0
3) Configure MPLS TE basic capabilities, and enable RSVP-TE and CSPF.
# Configure Switch A.
[SwitchA] mpls lsr-id 1.1.1.1
[SwitchA] mpls
[SwitchA-mpls] mpls te
[SwitchA-mpls] mpls rsvp-te
[SwitchA-mpls] mpls te cspf
[SwitchA-mpls] quit
[SwitchA] interface vlan-interface 1
[SwitchA-Vlan-interface1] mpls
[SwitchA-Vlan-interface1] mpls te
[SwitchA-Vlan-interface1] mpls rsvp-te
[SwitchA-Vlan-interface1] quit
# Configure Switch B.
[SwitchB] mpls lsr-id 2.2.2.2
[SwitchB] mpls
[SwitchB-mpls] mpls te
[SwitchB-mpls] mpls rsvp-te
4.1.1.2/24
Routes : 13
Pre Cost NextHop
0 127.0.0.1
0 2.1.1.1
0 127.0.0.1
15 10 2.1.1.2
15 20 2.1.1.2
15 20 2.1.1.2
15 30 2.1.1.2
15 20 2.1.1.2
15 30 2.1.1.2
15 30 2.1.1.2
15 20 2.1.1.2
0 127.0.0.1
0 127.0.0.1
1-57
Figure 1-10)
Interface
InLoop0
Vlan1
InLoop0
Vlan1
Vlan1
Vlan1
Vlan1
Vlan1
Vlan1
Vlan1
Vlan1
InLoop0
InLoop0