Configuring Rsvp-Te Advanced Features - 3Com S7906E Configuration Manual

Establishing an MPLS TE tunnel with RSVP-TE
Follow these steps to establish an MPLS TE tunnel with RSVP-TE:
To do...
Enter system view
Enter MPLS view
Enable RSVP-TE on your
device
Exit to system view
Enter interface view of MPLS
TE link
Enable RSVP-TE on the
interface
Enter MPLS TE tunnel interface
view
Set the signaling protocol for
setting up the MPLS TE tunnel
to RSVP-TE
Submit current tunnel
configuration
To use RSVP-TE as the signaling protocol for setting up the MPLS TE tunnel, you must enable both
MPLS TE and RSVP-TE on the interface for the tunnel to use.

Configuring RSVP-TE Advanced Features

RSVP-TE adds new objects in Path and Resv messages to support CR-LSP setup. RSVP-TE provides
many configurable options with respect to reliability, network resources, and other advanced features of
MPLS TE.
Before performing the configuration tasks in this section, be aware of each configuration objective and
its impact on your network.
Configuration Prerequisites
Before configuring RSVP-TE advanced features, do the following:
Configure MPLS basic capabilities
Configure MPLS TE basic capabilities
Establish an MPLS TE tunnel with RSVP-TE
Configuration Procedure
Configuring RSVP-TE advanced features involves these tasks:
Use the command...
system-view
mpls
mpls rsvp-te
quit
interface interface-type
interface-number
mpls rsvp-te
interface tunnel
tunnel-number
mpls te signal-protocol
rsvp-te
mpls te commit
1-21
Remarks
––
––
Required
Disabled by default
––
––
Required
Disabled by default
––
Optional
RSVP-TE applies by default.
Required