3Com S7906E Configuration Manual page 2427

Execute the display rmon statistics command on Agent to display the statistics result, and query
the statistics on the NMS.
Figure 1-3 Network diagram for RMON
Configuration procedure
# Configure the SNMP agent. (Note that parameter values configured on the agent must be the same
with the following configured on the NMS: suppose SNMPv1 is enabled on the NMS, the read
community name is public, the write community name is private, the IP address of the NMS is 1.1.1.2,
authentication protocol is MD5, authorization password is authkey, the privacy protocol is DES56, and
the privacy password is prikey.)
<Sysname> system-view
[Sysname] snmp-agent
[Sysname] snmp-agent community read public
[Sysname] snmp-agent community write private
[Sysname] snmp-agent sys-info version v1
[Sysname] snmp-agent trap enable
[Sysname] snmp-agent target-host trap address udp-domain 1.1.1.2 params securityname public
# Configure RMON to gather statistics on interface GigabitEthernet 2/0/1.
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] rmon statistics 1 owner user1
[Sysname-GigabitEthernet2/0/1] quit
# Create an RMON alarm entry that when the delta sampling value of node 1.3.6.1.2.1.16.1.1.1.4.1
exceeds 100 or is lower than 50, event 1 is triggered to send traps.
[Sysname] rmon event 1 trap public owner user1
[Sysname] rmon alarm
falling-threshold 50 1
# Display the RMON alarm entry configuration.
<Sysname> display rmon alarm 1
AlarmEntry 1 owned by null is Valid.
Samples type
Variable formula
Sampling interval
Rising threshold
Falling threshold
When startup enables
Latest value
# Display statistics for interface GigabitEthernet 2/0/1.
1 1.3.6.1.2.1.16.1.1.1.4.1
: delta
: 1.3.6.1.2.1.16.1.1.1.4.1<etherStatsOctets.1>
: 5(sec)
: 100(linked with event 1)
: 50(linked with event 2)
: risingOrFallingAlarm
: 0
1-10
5 delta rising-threshold 100 1