3Com S7906E Configuration Manual page 2342

To do...
Configure the authentication
mode when a user uses the
current user interface to log in
to the device
Configure the privilege level of
the user logging in from the
current user interface
Follow these steps to configure the user privilege level under a user interface (none or password
authentication mode):
To do...
Enter system view
Enter user interface view
Configure the authentication
mode when a user uses the
current user interface to log in
to the device
Configure the privilege level of
the user logging in from the
current user interface
4) Example of configuring user privilege level under a user interface
Perform no authentication to the users telnetting to the device, and specify the user privilege level
as 1. (This configuration brings potential security problem. Therefore, you are recommended to use
it only in a lab environment.)
<Sysname> system-view
[Sysname] user-interface vty 0 4
[Sysname-ui-vty0-4] authentication-mode none
[Sysname-ui-vty0-4] user privilege level 1
By default, when users telnet to the device, they can only use the following commands after passing the
authentication:
<Sysname> ?
User view commands:
cluster Run cluster command
display Display current system information
Use the command...
authentication-mode scheme
user privilege level level
Use the command...
system-view
user-interface { first-num1
[ last-num1 ] | { aux | vty }
first-num2 [ last-num2 ] }
authentication-mode { none |
password }
user privilege level level
1-13
Remarks
Optional
By default, the authentication
mode for VTY user interfaces is
password, and AUX user
interfaces do not need
authentication.
Optional
By default, the user privilege
level for users logging in from
the console user interface is 3,
and that for users logging from
the other user interfaces is 0.
Remarks
—
—
Optional
By default, the authentication
mode for VTY user interfaces is
password, and AUX user
interfaces do not need
authentication.
Optional
By default, the user privilege
level for users logging in from
the console user interface is 3,
and that for users logging from
the other user interfaces is 0.