3Com S7906E Configuration Manual page 2327

To do...
Create a basic ACL or enter
basic ACL view
Define rules for the ACL
Quit to system view
Apply the ACL while configuring
the SNMP community name
Apply the ACL while configuring
the SNMP group name
Apply the ACL while configuring
the SNMP user name
Configuration Example
Network requirements
Only SNMP users sourced from the IP addresses of 10.110.100.52 and 10.110.100.46 are permitted to
access the switch.
Use the command...
acl [ ipv6 ] number acl-number
[ match-order { config | auto } ]
rule [ rule-id ] { permit | deny }
[ source { sour-addr sour-wildcard |
any } | time-range time-name |
fragment | logging ]*
quit
snmp-agent community { read |
write } community-name [ mib-view
view-name | acl acl-number ]*
snmp-agent group { v1 | v2c }
group-name [ read-view read-view ]
[ write-view write-view
[ notify-view notify-view ] [ acl
acl-number ]
snmp-agent group v3 group-name
[ authentication |
[ read-view read-view ] [ write-view
write-view ] [
notify-view ] [ acl acl-number ]
snmp-agent usm-user { v1 | v2c }
user-name group-name
acl-number ]
snmp-agent usm-user
user-name group-name [ [ cipher ]
authentication-mode { md5 | sha }
auth-password [ privacy-mode
{ aes128 | des56 } priv-password ] ]
[ acl acl-number ]
8-5
Remarks
As for the acl number
command,
keyword is specified by
default.
Required
—
]
Required
According to the SNMP
version and configuration
customs of NMS users,
privacy ]
you can reference an ACL
when
notify-view
community name, group
name or username. For
the detailed configuration,
refer
[ acl
Configuration
System Volume.
v3
the config
configuring
to SNMP
in the