3Com S7906E Configuration Manual page 2144

# Display the smart link group configuration on Device C.
[DeviceC] display smart-link group all
Smart link group 1 information:
Device ID: 000f-e23d-5af0
Preemption mode: ROLE
Control VLAN: 10
Protected VLAN: Reference Instance 0
Member
-------------------------------------------------------------------------------
GigabitEthernet2/0/1
GigabitEthernet2/0/2
Smart link group 2 information:
Device ID: 000f-e23d-5af0
Preemption mode: ROLE
Control VLAN: 101
Protected VLAN: Reference Instance 2
Member
-------------------------------------------------------------------------------
GigabitEthernet2/0/2
GigabitEthernet2/0/1
You can use the display smart-link flush command to display the flush messages received on each
device. For example:
# Display the flush messages received on Device B.
[DeviceB] display smart-link flush
Received flush packets
Receiving interface of the last flush packet
Receiving time of the last flush packet
Device ID of the last flush packet
Control VLAN of the last flush packet
Role State Flush-count Last-flush-time
MASTER ACTVIE 5
SLAVE STANDBY 1
Role State Flush-count Last-flush-time
MASTER ACTVIE 5
SLAVE STANDBY 1
1-18
16:37:20 2009/02/21
17:45:20 2009/02/21
16:37:20 2009/02/21
17:45:20 2009/02/21
: 5
: GigabitEthernet2/0/2
: 16:25:21 2009/02/21
: 000f-e23d-5af0
: 10