Configuring An Http Test - 3Com S7906E Configuration Manual

When you execute the put command, a file file-name with fixed size and content is created on the
FTP server; when you execute the get command, the device does not save the files obtained from
the FTP server.
When you execute the get command, the FTP test cannot succeed if a file named file-name does
not exist on the FTP server.
When you execute the get command, please use a file with a smaller size as a big file may result in
test failure because of timeout, or may affect other services because of occupying too much
network bandwidth.

Configuring an HTTP Test

An HTTP test is used to test the connection between the NQA client and a specified HTTP server and
the time required to obtain data from the HTTP server, thus detecting the connectivity and performance
of the HTTP server.
Configuration prerequisites
Before performing an HTTP test, you need to configure the HTTP server.
Configuring an HTTP test
Follow these steps to configure an HTTP test:
To do...
Enter system view
Enter NQA test group view
Configure the test type as
HTTP and enter test type view
Configure the destination
address for a test operation
Configure the source IP
address of a probe request
Use the command...
system-view
nqa entry admin-name
operation-tag
type http
destination ip ip-address
source ip ip-address
1-10
Remarks
—
—
Required
Required
By default, no destination IP
address is configured for a test
operation.
The destination IP address for
a test operation is the IP
address of the HTTP server.
Optional
By default, no source IP
address is specified.
The source IP address must be
that of an interface on the
device and the interface must
be up. Otherwise, the test will
fail.