3Com S7906E Configuration Manual page 2264

Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface Vlan-interface2
VRID : 1
Admin Status : Up
Config Pri : 100
Preempt Mode : Yes
Auth Type : None
Virtual IP : 192.168.0.10
Master IP : 192.168.0.101
The above output shows that when the status of track entry 1 becomes Positive, Switch A is the master
and Switch B the backup.
# When the uplink of Switch A goes down, track entry 1 becomes Negative.
<RouterA> display track 1
Track ID: 1
Status: Negative
Notification delay: Positive 0, Negative 0 (in seconds)
Reference object:
BFD session:
Packet type: Echo
Interface : Vlan-interface2
Remote IP : 1.1.1.2
Local IP : 1.1.1.1
# display the detailed information of VRRP group 1 on Switch A.
<SwitchA> display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface Vlan-interface2
VRID : 1
Admin Status : Up
Config Pri : 110
Preempt Mode : Yes
Auth Type : None
Virtual IP : 192.168.0.10
Master IP : 192.168.0.102
VRRP Track Information:
Track Object : 1
# Display the detailed information of VRRP group 1 on Switch B.
<SwitchB> display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 1
Adver Timer : 1
State : Backup
Running Pri : 100
Delay Time : 0
Adver Timer : 1
State : Backup
Running Pri : 90
Delay Time : 0
State : Negative
1-16
Pri Reduced : 20