Configuring An Snmp Test - 3Com S7906E Configuration Manual

To do...
Configure common optional
parameters
The number of probes made in a UDP jitter test depends on the probe count command, while the
number of probe packets sent in each probe depends on the configuration of the probe
packet-number command.

Configuring an SNMP Test

An SNMP query test is used to test the time the NQA client takes to send an SNMP query packet to the
SNMP agent and then receive a response packet.
Configuration prerequisites
The SNMP agent function must be enabled on the device serving as an SNMP agent before an SNMP
test. For the configuration of SNMP agent, refer to SNMP Configuration in the System Volume.
Configuring an SNMP test
Follow these steps to configure an SNMP test:
To do...
Enter system view
Enter NQA test group view
Configure the test type as
SNMP and enter test type view
Configure the destination
address for a test operation
Specify the source port number
for a probe request in a test
operation
Configure the source IP
address of a probe request in a
test operation
Configure common optional
parameters
Use the command...
Refer to Configuring
Optional Parameters
Common to an NQA Test
Group
Use the command...
system-view
nqa entry admin-name
operation-tag
type snmp
destination ip ip-address
source port port-number
source ip ip-address
Refer to Configuring Optional
Parameters Common to an
NQA Test Group
1-13
Remarks
Optional
Remarks
—
—
Required
Required
By default, no destination IP
address is configured for a test
operation.
Optional
By default, no source port number
is specified.
Optional
By default, no source IP address
is specified.
The source IP address must be
that of an interface on the device
and the interface must be up.
Otherwise, the test will fail.
Optional