Creating An Rrpp Domain - 3Com S7906E Configuration Manual

Complete the following tasks to configure RRPP:

Creating an RRPP Domain

Configuring Control VLANs
Configuring Protected VLANs
Configuring
RRPP Rings
Activating an RRPP Domain
Configuring RRPP Timers
Configuring
RRPP Fast
Detection
Configuring an RRPP Ring Group
RRPP does not have an auto election mechanism, so you must configure each node in the ring
network properly for RRPP to monitor and protect the ring network.
Before configuring RRPP, you need to construct a ring-shaped Ethernet topology physically.
Creating an RRPP Domain
When creating an RRPP domain, specify a domain ID, which uniquely identifies an RRPP domain. All
devices in the same RRPP domain must be configured with the same domain ID.
Make this configuration on devices you want to configure as nodes in the RRPP domain.
Task
Configuring RRPP Ports
Configuring RRPP Nodes
Enabling Fast Detection
Configuring Fast
Detection Timers
Required
Perform this task on all nodes in the RRPP domain.
Required
Perform this task on all nodes in the RRPP domain.
Required
Perform this task on all nodes in the RRPP domain.
Required
Perform this task on all nodes in the RRPP domain.
Required
Perform this task on all nodes in the RRPP domain
Required
Perform this task on all nodes in the RRPP domain.
Optional
Perform this task on the master node in the RRPP
domain.
Optional
Perform this task on the master node, edge node, and
assistant-edge node in the RRPP domain.
Optional
Perform this task on the master node in the RRPP
domain.
Optional
Perform this task on the edge node and
assistant-edge node in the RRPP domain.
1-11
Remarks