<IRF> tftp 2.2.2.2 get soft-version2.app chassis1#slot1#flash:/soft-version2.app
<IRF> tftp 2.2.2.2 get soft-version2.app chassis2#slot0#flash:/soft-version2.app
<IRF> tftp 2.2.2.2 get soft-version2.app chassis2#slot1#flash:/soft-version2.app
# Specify file new-config.cfg as the boot file for the next boot of all IRF member devices.
<IRF> startup saved-configuration new-config.cfg
Please wait ...
Setting the master board ...
... Done!
Setting the slave board ...
Chassis 1 Slot 1:
Set next configuration file successfully.
Chassis 2 Slot 0:
Set next configuration file successfully.
Chassis 2 Slot 1:
Set next configuration file successfully.
# Specify file soft-version2.app as the boot file for the next boot of all SRPUs.
<IRF> boot-loader file soft-version2.app chassis 1 slot 0 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis 1 slot
0!
<IRF> boot-loader file chassis1#slot1#flash:/soft-version2.app chassis 1 slot 1 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis 1 slot
1!
<IRF> boot-loader file chassis2#slot0#flash:/soft-version2.app chassis 2 slot 0 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis 2 slot
0!
<IRF> boot-loader file chassis2#slot1#flash:/soft-version2.app chassis 2 slot 1 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis 2 slot
1!
# Reboot the device. The software version is upgraded now.
<IRF> reboot
After the device reboots, use the display version command to check if the upgrade is successful.
1-24