Device Management Configuration Task List; Configuring The Exception Handling Method - 3Com S7906E Configuration Manual

Device Management Configuration Task List

Complete these tasks to configure device management:

Configuring the Exception Handling Method

Rebooting a Device
Configuring the Scheduled Automatic Execution Function
Upgrading Device Software
Configuring Temperature Alarm Thresholds for a board
Clearing the 16-bit Interface Indexes Not Used in the Current System
Configuring the System Load Sharing Function
Enabling Active/Standby Mode for Service Ports on SRPUs
Configuring the Traffic Forwarding Mode of SRPUs
Configuring the Working Mode of LPUs
Enabling the Port Down Function Globally
Enabling Expansion Memory Data Recovery Function on a board
Identifying and Diagnosing Pluggable Transceivers
Configuring the Exception Handling Method
When the system detects any software abnormality, it handles the situation with one of the following two
methods:
reboot: The system recovers itself through automatic reboot.
maintain: The system maintains the current situation, and does not take any measure to recover
itself. Therefore, you need to recover the system manually, such as reboot the system. Sometimes,
it is difficult for the system to recover, or some prompts that are printed during the failure are lost
after the reboot. In this case, you can use this method to maintain the abnormal state to locate
problems and recover the system.
Follow these steps to configure the exception handling method (distributed device):
To do...
Enter system view
Configure the exception
handling method on the active
switching and routing
processing unit (SRPU) and the
standby SRPU
Task
Use the command...
system-view
system-failure { maintain |
reboot }
1-2
Remarks
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Remarks
—
Optional
By default, the active SRPU
and the standby SRPU adopt
the reboot method to handle
exceptions.