3Com S7906E Configuration Manual page 1708

Perform the display interface tunnel command on Switch A. You can find that Tunnel4 is up.
[SwitchA] display interface tunnel
Tunnel4 current state: UP
Line protocol current state: UP
Description: Tunnel4 Interface
The Maximum Transmit Unit is 64000
Internet Address is 10.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set
Tunnel source unknown, destination 4.4.4.4
Tunnel protocol/transport CR_LSP
Last 300 seconds input:
Last 300 seconds output:
0 packets input,
0 input error
0 packets output,
0 output error
Perform the display mpls te tunnel-interface command on Switch A to verify the configuration of the
tunnel interface.
[SwitchA] display mpls te tunnel-interface
Tunnel Name
Tunnel Desc
Tunnel State Desc
Tunnel Attributes
LSP ID
Session ID
Admin State
Ingress LSR ID
Signaling Prot
Class Type
Reserved BW
Setup Priority
Affinity Prop/Mask
Explicit Path Name
Tie-Breaking Policy :
Metric Type
Record Route
FRR Flag
BackUpBW Type
Route Pinning
Retry Limit
Reopt
Back Up Type
Back Up LSPID
Auto BW
Min BW
Current Collected BW:
Interfaces Protected:
0 bytes/sec, 0 packets/sec
0 bytes/sec, 0 packets/sec
0 bytes
0 bytes
: Tunnel4
: Tunnel4 Interface
: CR-LSP is Up
:
: 1.1.1.1:1
: 10
: UP
: 1.1.1.1
: RSVP
: CLASS 0
: 0 kbps
: 7
: 0/0
: pri-path
None
: None
: Enabled Record Label :
: Enabled BackUpBW Flag:
: - BackUpBW
: Disabled
: 5
: Disabled
: None
: -
: Disabled
: -
-
-
1-59
Oper State : UP
Egress LSR ID: 4.4.4.4
Resv Style : SE
Tunnel BW : 0 kbps
Hold Priority: 7
Enabled
Not Supported
: -
Retry Interval: 10 sec
Reopt Freq : -
Auto BW Freq : -
Max BW : -