Mpls Te Configuration Examples; Mpls Te Using Static Cr-Lsp Configuration Example - 3Com S7906E Configuration Manual

To do...
Display information about
sub-TLVs for the IS-IS TE
extension
Display information about
tunnels
Clear the statistics about
RSVP-TE

MPLS TE Configuration Examples

MPLS TE Using Static CR-LSP Configuration Example

Network requirements
Switch A, Switch B, and Switch C run IS-IS.
Establish a TE tunnel using a static CR-LSP between Switch A and Switch C.
Figure 1-6 Set up MPLS TE tunnels using static CR-LSPs
Vlan-int1
2.1.1.2/24
Vlan-int1
2.1.1.1/24
Switch A
Loop0
1.1.1.1/32
Configuration procedure
1) Assign IP addresses and masks to interfaces (see
Omitted
2) Enable IS-IS to advertise host routes with LSR IDs as destinations
# Configure Switch A.
<SwitchA> system-view
[SwitchA] isis 1
[SwitchA-isis-1] network-entity 00.0005.0000.0000.0001.00
[SwitchA-isis-1] quit
[SwitchA] interface vlan-interface 1
[SwitchA-Vlan-interface1] isis enable 1
Use the command...
display isis traffic-eng
sub-tlvs [ process-id |
vpn-instance
vpn-instance-name ]
display tunnel-info { tunnel-id
| all | statistics }
reset mpls rsvp-te statistics
{ global | interface
[ interface-type
interface-number ]
Loop0
2.2.2.2/32
Vlan-int2
3.2.1.1/24
Switch B
Vlan-int2
3.2.1.2/24
Switch C
Loop0
3.3.3.3/32
Figure 1-6)
1-40
Remarks
Available in any view
Available in any view
Available in user view