3Com S7906E Configuration Manual page 1714

Out-Label
In-Interface
Out-Interface
LspIndex
Tunnel ID
LsrType
Bypass In Use
BypassTunnel
Mpls-Mtu
No
IngressLsrID
LocalLspID
Tunnel-Interface
Fec
Nexthop
In-Label
Out-Label
In-Interface
Out-Interface
LspIndex
Tunnel ID
LsrType
Bypass In Use
BypassTunnel
Mpls-Mtu
# Set the FRR polling timer to five seconds on PLR.
[SwitchB] mpls
[SwitchB-mpls] mpls te timer fast-reroute 5
[SwitchB-mpls] quit
# Bring the protected outgoing interface up on PLR.
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] undo shutdown
%Sep 7 09:01:31 2004 SwitchB IFNET/5/UPDOWN:Line protocol on the interface Vlan-interface2
turns into UP state
Perform the display interface tunnel 4 command on Switch A to identify the state of the primary LSP.
You can find that the tunnel interface is up.
About 5 seconds later, perform the display mpls lsp verbose command on Switch B. You can find that
Tunnel5 is still bound with interface VLAN-interface 2 and is unused.
7) Create a static route for routing MPLS TE tunnel traffic
[SwitchA] ip route-static 4.1.1.2 24 tunnel 4 preference 1
Perform the display ip routing-table command on Switch A. You can find a static route entry with
Tunnel4 as the outgoing interface.
: 1024
: Vlan-interface1
: Vlan-interface2
: 4097
: 0x22001
: Transit
: In Use
: Tunnel Index[Tunnel5], InnerLabel[1024]
: 1500
: 2
: 2.2.2.2
: 1
: Tunnel5
: 3.3.3.3/32
: 3.2.1.2
: NULL
: 1024
: ----------
: Vlan-interface4
: 4098
: 0x22002
: Ingress
: Not Exists
: Tunnel Index[---]
: 1500
1-65