3Com S7906E Configuration Manual page 1698

[SwitchA-Tunnel1] tunnel-protocol mpls te
[SwitchA-Tunnel1] destination 4.4.4.9
[SwitchA-Tunnel1] mpls te tunnel-id 10
[SwitchA-Tunnel1] mpls te signal-protocol rsvp-te
[SwitchA-Tunnel1] mpls te bandwidth 2000
[SwitchA-Tunnel1] mpls te commit
[SwitchA-Tunnel1] quit
6) Verify the configuration
Perform the display interface tunnel command on Switch A. You can find that the tunnel interface is
up.
[SwitchA] display interface tunnel
Tunnel1 current state: UP
Line protocol current state: UP
Description: Tunnel1 Interface
The Maximum Transmit Unit is 64000
Internet Address is 7.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set
Tunnel source unknown, destination 4.4.4.9
Tunnel protocol/transport CR_LSP
Last 300 seconds input:
Last 300 seconds output:
0 packets input,
0 input error
0 packets output,
0 output error
Perform the display mpls te tunnel-interface command on Switch A to verify information about the
MPLS TE tunnel.
[SwitchA] display mpls te tunnel-interface
Tunnel Name
Tunnel Desc
Tunnel State Desc :
Tunnel Attributes :
LSP ID
Session ID
Admin State
Ingress LSR ID
Signaling Prot
Class Type
Reserved BW
Setup Priority
Affinity Prop/Mask
Explicit Path Name
Tie-Breaking Policy :
Metric Type
Record Route
FRR Flag
0 bytes/sec, 0 packets/sec
0 bytes/sec, 0 packets/sec
0 bytes
0 bytes
: Tunnel1
: Tunnel1 Interface
CR-LSP is Up
: 1.1.1.9:3
: 10
: UP
: 1.1.1.9
: RSVP
: CLASS 0
: 0 kbps
: 7
: 0x0/0x0
: -
None
: None
: Disabled Record Label :
: Disabled BackUpBW Flag:
1-49
Oper State : UP
Egress LSR ID: 4.4.4.9
Resv Style : SE
Tunnel BW : 0 kbps
Hold Priority: 7
Disabled
Not Supported