Static Routing-Track-Nqa Collaboration Configuration Example - 3Com S7906E Configuration Manual

Interface Vlan-interface2
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
The above output indicates that when Switch A detects that the uplink fails through BFD, it decreases its
priority by 20 to ensure that Switch B can preempt as the master.

Static Routing-Track-NQA Collaboration Configuration Example

Network requirements
As shown in
Configure Static Routing-Track-NQA collaboration on Switch A to implement real-time monitoring
of the validity of the static route to Switch C.
Figure 1-5 Network diagram for Static Routing-Track-NQA collaboration configuration
Vlan-int3
10.2.1.1/24
Vlan-int3
10.2.1.2/24
Switch A
Configuration procedure
1) Configure the IP address of each interface as shown in
2) Configure a static route on Switch A and associate it with the track entry.
# Configure the address of the next hop of the static route to Switch C as 10.2.1.1, and configure the
static route to associate with track entry 1.
<SwitchA> system-view
[SwitchA] ip route-static 10.1.1.2 24 10.2.1.1 track 1
3) Configure an NQA test group on Switch A.
# Create an NQA test group with the administrator admin and the operation tag test.
[SwitchA] nqa entry admin test
# Configure the test type as ICMP-echo.
[SwitchA-nqa-admin-test] type icmp-echo
# Configure the destination address as 10.2.1.1
[SwitchA-nqa-admin-test-icmp-echo] destination ip 10.2.1.1
: 1
: Up
: 100
: Yes
: None
: 192.168.0.10
: 0000-5e00-0101
: 192.168.0.102
Figure 1-5, the next hop of the static route from Switch A to Switch C is Switch B.
Switch B
Vlan-int2
10.1.1.1/24
Vlan-int2
10.1.1.2/24
Switch C
Adver Timer : 1
State : Master
Running Pri : 100
Delay Time : 0
Figure 1-5.
1-17