3Com S7906E Configuration Manual page 1718

[PE1-Tunnel1] mpls te signal-protocol rsvp-te
[PE1-Tunnel1] mpls te commit
[PE1-Tunnel1] quit
Perform the display interface tunnel command on PE 1. You can see that the tunnel interface is up.
# Create a TE tunnel with PE 2 as the headend and PE 1 as the tail. The signaling protocol is RSVP-TE.
[PE2] mpls
[PE2-mpls] mpls rsvp-te
[PE2-mpls] quit
[PE2] interface vlan-interface 2
[PE2-Vlan-interface2] mpls rsvp-te
[PE2-Vlan-interface2] quit
[PE2] interface tunnel 1
[PE2-Tunnel1] ip address 12.1.1.2 255.255.255.0
[PE2-Tunnel1] tunnel-protocol mpls te
[PE2-Tunnel1] destination 2.2.2.2
[PE2-Tunnel1] mpls te tunnel-id 10
[PE2-Tunnel1] mpls te signal-protocol rsvp-te
[PE2-Tunnel1] mpls te commit
[PE2-Tunnel1] quit
Perform the display interface tunnel command on PE 2. You can see that the tunnel interface is up.
5) Configure the VPN instance on each PE, and bind it to the interface connected to the CE
# Configure on CE 1.
[CE1] interface vlan-interface 1
[CE1-Vlan-interface1] ip address 192.168.1.2 255.255.255.0
[CE1-Vlan-interface1] quit
# Configure the VPN instance on PE 1, and use CR-LSP for VPN setup. Bind the VPN instance with the
interface connected to CE 1.
[PE1] ip vpn-instance vpn1
[PE1-vpn-instance-vpn1] route-distinguisher 100:1
[PE1-vpn-instance-vpn1] vpn-target 100:1 both
[PE1-vpn-instance-vpn1] tnl-policy policy1
[PE1-vpn-instance-vpn1] quit
[PE1] tunnel-policy policy1
[PE1-tunnel-policy-policy1] tunnel select-seq cr-lsp load-balance-number 1
[PE1-tunnel-policy-policy1] quit
[PE1] interface vlan-interface 1
[PE1-Vlan-interface1] ip binding vpn-instance vpn1
[PE1-Vlan-interface1] ip address 192.168.1.1 255.255.255.0
[PE1-Vlan-interface1] quit
# Configure on CE 2.
[CE2] interface vlan-interface 3
[CE2-Vlan-interface3] ip address 192.168.2.2 255.255.255.0
[CE2-Vlan-interface3] quit
# Configure the VPN instance on PE 2, and bind it with the interface connected to CE 2.
1-69